SecurityMan ClearCam Uživatelská příručka stáhnout pdf (Strana 16)

B) Setting up the Camera

1) Set the camera to desired Dip-Switch Channel Frequency

2) Place the camera in a desired location.

3) Plug the power adapter jack into the power jack

4) Plug the power adapter to any AC/DC outlet

5) Jot down the Dip-Switch Channel of each camera. (The receiver

will receive signal from the corresponding camera and display

one at the time. For example, Channel 1 light on the receiver will

display the image from Camera 1 only).

C) Setting up the Receiver for manual or loop mode

1) Basically, the receiver is already set to match the camera by

default(CH1 & Manual). To setup "Loop" mode the A B switch

to "Loop" located at the rear of the receiver.

Note: only use "Loop"mode if two cameras are in used.

1 2

ON GDH02

Power Jack

Default Mode

1 2 ... 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

SecurityMan ClearCam Uživatelská příručka Strana 16